2 Pack Windshield Wiper Anti-Freeze Stands – 3D Printed PLA Wiper Protectors
2 Pack Windshield Wiper Anti-Freeze Stands – 3D Printed PLA Wiper Protectors
BUNDLE & SAVE
Couldn't load pickup availability
- American express payment method
- Apple pay payment method
- Bancontact payment method
- Bizum payment method
- Diners club payment method
- Discover payment method
- Google pay payment method
- Master payment method
- Mbway payment method
- Paypal payment method
- Satispay payment method
- Shopify pay payment method
- Visa payment method
-
Ordered
- - -
Order Ready
- - -
Delivered
2 Pack Windshield Wiper Anti-Freeze Stands – 3D Printed PLA Wiper Protectors
Keep the Blades Off the Glass Tonight.
Two small stands that lift the wiper arm away from the windscreen while the car is parked.
With a gap between rubber and glass, overnight ice cannot weld the blade down — so it lifts free in the morning instead of tearing.
A Gap Instead of a Frozen Seal.
Meltwater normally refreezes around the blade and locks it to the glass. Holding the arm up keeps that contact from forming.
Less ice adhesion means less strain on the rubber and the wiper motor when you start the car.
3D Printed PLA, Solid Under Load.
Each stand is 3D printed in PLA with a rigid column, a reinforced geometric body and a textured surface.
It is lightweight enough to leave in the boot, and rigid enough to hold a wiper arm without collapsing.
Lift, Place, Lower. No Tools.
The groove cradles the arm, and the wide polygonal base keeps the stand steady on the glass.
- Lift the wiper arm away from the glass
- Stand the support on the windscreen beneath it
- Lower the arm into the recessed top groove
6 cm Tall, 3 cm Wide.
Each support measures about 6 cm tall and 3 cm wide (2.36 × 1.18 in), small enough to store in a door pocket or glovebox.
Check the clearance under your wiper arm before relying on them.
What Changes Overnight.
Without support: blade frozen to the glass, ice build-up along the rubber, and a wiper that judders or tears when you use it.
With support: the blade stays clear, the arm lifts normally, and the morning routine is shorter.
At a Glance
| Pack | 2 wiper support stands |
| Material | 3D printed PLA plastic |
| Size | Approx. 6 cm tall × 3 cm wide (2.36 × 1.18 in) |
| Design | Recessed top groove, wide polygonal base |
| Install | Lift arm, place stand, lower arm — no tools |
| Use | Overnight parking in freezing or snowy weather |
| Storage | Glovebox or door pocket |
Remove the stands before driving. They are a parking aid, not a driving accessory.
Two Stands. One Less Frozen Morning.
One pair covers both wipers.
